Concrete Group of Lakeland installs them in Lakeland, replacing dirt paths that wash out and slabs that have cracked, so you get firm footing that doesn't turn to mud.
How do I know my walkway needs replacing?
Replace it when the slab has cracked through, shifted out of level, or holds puddles after rain. Those point to ground that moved or water that never had a way off, and a patch won't fix either. Concrete Group of Lakeland replaces failed walkways across Lakeland by taking out the soft ground and setting the new path to a fresh grade.
A dirt path that keeps washing out starts with the sod cutter instead of demolition. Either way, the new walkway is built from the base up.
Worth comparing with concrete slab and foundation installation. Searching for a concrete contractor in Lakeland? Our home page covers it.
Worth a read: Budgeting for Concrete Work: Real Price Ranges Explained · When a Problem Calls for Concrete Work: Signs to Watch
When is the best time to pour a walkway in Lakeland?
Lakeland has a pronounced summer wet season, and heavy rain can get in the way of earthwork and subgrade prep. Concrete Group of Lakeland schedules the digging and base work around the forecast and pours once the ground is workable. We'd rather move a pour day than build a path on soaked soil.
Temperature isn't the constraint here. The January average low is 52.8°F and the July average high is 91.0°F, a seasonal range of about 38°F, so the rain calendar drives our scheduling more than the thermometer.
What steps do you follow once the crew breaks ground?
Concrete Group of Lakeland cuts the sod with a sod cutter and shovel, then sets mason's string and stakes to mark the path. The gravel base is dampened without leaving standing water, the concrete is placed and spread inside the forms, then screeded to the intended profile, floated, and edged along the forms.
The string line gives the screed its height and direction, so the finished surface follows the layout instead of the eye. The base should be damp, not wet: dry gravel pulls water out of the fresh concrete, and standing water leaves the slab weak. Edging along the forms gives the walkway a finished edge.
What does a walkway cost, and what changes the price?
A standard-finish concrete walkway or sidewalk from Concrete Group of Lakeland in Lakeland runs $7 to $11 per square foot installed. A typical range is available on the first call, and the firm number comes after we've walked the site and measured the run.
For scale, a path 3 feet wide and 30 feet long is 90 square feet, so roughly $725 to $1,100 at the standard finish. Poor soil to dig out, a subbase, a different finish, or a cramped site will push a quote past that range, and the written quote spells out which of those apply.
How do you handle Lakeland's heavy rain and drainage?
Concrete Group of Lakeland plans grading and drainage before any concrete goes down, because Lakeland rain comes in volume. During Hurricane Milton in 2024, parts of the city saw more than a foot in a single day. The goal is simple: water should leave the path, not sit on it or soak the base under it.
The same string line and stakes that mark the path let us check the fall before the concrete arrives. Soft spots found during digging get taken out rather than poured over, since ground that holds water is ground that moves.
Inside the Job
Spelled out, some of what gets done:
- When the surface is ready, broom it to create a textured finish and form control joints before the concrete hardens.
- Keep the concrete damp or covered during initial curing, then remove the forms and backfill along the walkway.
Other Services We Offer
What to Expect to Pay
These ranges are a starting point for planning, and we'll go over what pushes a job toward either end.
$8.00–$11.50 per square foot
Example: about $800–$1,150 for 100 sq ft
$1,250–$3,050
$2.50–$6.50 per square foot
Fast Scheduling
A short call is usually enough, you'll get an honest answer.